What are runway centreline lights?
A longitudinal line of lights installed along the runway centreline to provide precise directional guidance during takeoff, landing, and rollout.
Under ICAO Annex 14, runway centreline lights are required on CAT II and CAT III precision approach runways. They are also required on runways intended for take-off with operating minima below an RVR of the order of 400 m, and recommended on CAT I runways, particularly for high-speed aircraft or where the edge-light rows are more than 50 m apart. Installed along the runway centreline, they give the pilot directional guidance during the final approach, landing roll and take-off.
The lights are fixed lights showing variable white from the threshold to 900 m before the runway end. From 900 m to 300 m before the end they alternate red and white, and over the last 300 m they are solid red — a distance-to-go cue for the pilot rolling out, separate from the yellow caution zone of the edge lights. On a runway shorter than 1,800 m, the red/white alternation starts from the midpoint of the usable landing length.
Frequently Asked Questions
Q1What are runway centreline lights?
A longitudinal line of lights installed along the runway centreline that provides precise directional guidance during takeoff, landing and rollout, normally white.
Q2When are runway centreline lights required?
Required on CAT II and CAT III precision approach runways and on runways intended for take-off with operating minima below an RVR of the order of 400 m. Recommended on CAT I runways used by high-speed aircraft or where the edge-light rows are more than 50 m apart (ICAO Annex 14).
Q3Do runway centreline lights change colour near the runway end?
Yes. They are white until 900 m before the runway end, alternate red and white from 900 m to 300 m before the end, and are solid red over the last 300 m. This gives a distance-to-go cue that is separate from the yellow caution zone of the edge lights.
Q4Are runway centreline lights elevated or inset?
Inset (flush-mounted) fixtures, with adjustable intensity.
Q5How far apart are runway centreline lights?
About 15 m along the runway. Where the runway is used in RVR conditions of 350 m or greater and the serviceability objectives can be demonstrated, about 30 m is allowed (ICAO Annex 14; EASA CS-ADR-DSN.M.690).
See It. Understand It. Then Learn How to Engineer It.
Recognising an AGL system visually is the first step. The next step is knowing how to design, install, test, commission and maintain them correctly.
Build Practical AGL Engineering Skills
Go deeper with structured training from Precision AGL Academy, covering:
Learn how each light, sign and circuit works as part of a complete airport lighting system, not just as an isolated diagram.